Welcome to NZ Autospares

This listing is for 1 unit

Part Numbers:  59700B8800, 59700-B8800, 597002W800

Fits The Following:
HYUNDAI SANTAFE/MAXCRUZ MODEL 2012-2019

Note: this product is currently out of stock in NZ. This listing is for stock that is due to arrive in the country. we generally only keep 1 unit in stock of each item to reduce cost of holding inventory.

Feel free to ask questions or contact us. We are able to acquire a wide range of other parts through our suppliers. With 15 years experience we can find it for you.

Can't find it here check out our Trademe Store

 Electronic Handbrake Installations Instruction:

Step 1:
Preparation
-Make sure your vehicle is parked on a level surface and the parking brake is engaged.
-Disconnect the negative terminal of the vehicle battery to ensure safety during the installation.

Step 2:
Interior Components Installation
-Remove the center console or any necessary panels to access the area where the handbrake lever will be installed.
-Assemble the electronic handbrake lever and secure it to the designated location following the manufacturer's instructions.

Step 3:
Actuator Installation
-Locate a suitable position for the actuator, typically near the vehicle's rear brakes.
-Install the actuator using the provided brackets and hardware. Ensure it is securely fastened to the vehicle's chassis.

Step 4:
Cable Installation
-Route the electronic handbrake cables from the actuator to the handbrake lever following the recommended path, avoiding any sharp edges or moving parts.
-Attach the cables to the actuator and the handbrake lever, ensuring proper tension and alignment.

Step 5:
Wiring
-Connect the wiring harness from the electronic handbrake control module to the actuator and handbrake lever according to the manufacturer's instructions.
-Secure the wiring using zip ties and ensure it is protected from damage.

Step 6:
Electrical Connections
-Make the necessary electrical connections, including power, ground, and any other required connections, as specified in the installation manual.
-Follow the wiring diagram provided by the manufacturer to ensure proper connections and compatibility with your vehicle's electrical system.

Step 7:
Testing and Calibration
-Reconnect the vehicle's battery.
-Test the electronic handbrake system to ensure proper operation. Follow the calibration procedure outlined in the installation manual.

Step 8:
Finalization
-Reassemble any panels or components that were removed during the installation.
-Conduct a final test of the electronic handbrake to ensure everything is functioning correctly.